Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 131)

Brocade Network Advisor SAN User Manual 79
53-1003154-01
Server Data backup
4
3. Clear the Enable Backup check box.
4. Click Apply or OK.
Viewing the backup status
The Management application enables you to view the backup status at a glance by providing a
backup status icon on the Status Bar. The following table illustrates and describes the icons that
indicate the current status of the backup function.
Changing the backup interval
When the backup feature is enabled, your SAN is protected by automatic backups. The backups
occur every 24 hours by default. However, you can change the interval at which backup occurs.
NOTE
Do NOT modify the backup.properties file.
To change the backup interval, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Server Backup in the Category list.
3. Select an interval from the Backup Interval drop-down list to set how often backup occurs.
4. Click Apply or OK.
The minimum value is 6 hours and the maximum value is 24 hours.
TABLE 14 Backup status
Icon Description
Backup in Progress — displays the following tooltip: “Backup started at hh:mm:ss, in progress...
XX directories are backed up.”
Countdown to Next Scheduled Backup — displays the following tooltip: “Next backup scheduled
at hh:mm:ss.”
Backup Disabled — displays the following tooltip: “Backup is disabled.”
Backup Failed — displays the following tooltip: “Backup failed at hh:mm:ss mm/dd/yyyy.”