Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 385)

Brocade Network Advisor SAN User Manual 333
53-1003154-01
User-defined performance monitors
7
Configuring a user-defined product performance monitor
For creating a user-defined dashboard, refer to “Creating a user-defined dashboard” on page 269
and perform the following steps to configure a user-defined product performance monitor.
1. Click the Customize Dashboard icon.
The Customize Dashboard dialog box displays.
2. Click the Performance tab.
3. Click Add.
The Add Performance Dashboard Monitor dialog box displays.
4. Enter a unique title for the monitor.
The title can be up to 256 characters in length.
5. Select the type of monitor you are creating from the Monitor Type - Products area:
• Top N — Select to monitor the top N (number) products affected by the selected measure.
• Bottom N — Select to monitor the bottom N (number) products affected by the selected
measure.
• Distribution — Select to monitor the selected measure for five defined distribution
percentages.
• Time Series — Select to monitor a selected measure for a range of time and specified
target.
6. Select the product measure for the monitor in the Measure area:
• Memory Utilization Percentage
• CPU Utilization Percentage
• Temperature
• Fan Speed
• Response Time
• System Up Time
• Ports Not In Use
• Ping Packet Loss Percentage
• AP Client Count (not available for Time Series monitors)
7. (Top N and Bottom N monitors only) Select the number products to include in a selected
measure by entering a number in the For Top N, Bottom N Monitors, N= field.
Valid values are from 1 through 25. The default is 10.
8. (Top N, Bottom N, and Distribution monitors only) Configure the monitor to show only values
greater than or less than a specified value by completing the following steps.
a. Select the Show values check box.
b. Select greater than or less than from the list.
c. Enter a value in the field.