Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1516)

1464 Brocade Network Advisor SAN User Manual
53-1003154-01
About user privileges
D
TABLE 133 SAN privileges and application behavior
Privilege Description No Privilege Read-Only Read/Write
SAN - Discovery Setup Allows you to configure
discovery setup. Disables Setup on the
Discover menu and
toolbar. Enables Setup on the
Discover menu and
toolbar.
Allows you to open the
Discover Setup dialog
box; however, disables all
functions. Enables Setup on the
Discover menu and
toolbar.
Enables all functions in
the Discover Setup dialog
box.
SAN - Fabric Binding Allows you to configure
fabric binding. Disables the Fabric
Binding command. Enables the Fabric
Binding command;
however, disables
functions on the dialog
box. Enables the Fabric
Binding command and all
functions on the dialog
box.
SAN - Fabric Tracking Allows you to define the
current devices and
connections present in a
fabric as a baseline and
to highlight any changes
to that baseline. Disables the Track Fabric
Changes and Accept
Changes commands on
the Monitor menu and
right-click menus of
Fabrics. Same as no privilege. Enables the Track Fabric
Changes and Accept
Changes commands on
the Monitor menu and
right-click menus of
Fabrics.
SAN - FCIP Management Allows you to configure
FCIP tunnels and
troubleshooting of IP
interfaces (IP
performance, IP ping and
IP trace route). Disables the Configure >
FCIP Tunnel and Monitor
> Troubleshooting > FCIP
commands. Disables the
FCIP Tunnel command on
the Fabric right-click
menu. Enables the Configure >
FCIP Tunnel and Monitor
> Troubleshooting > FCIP
commands.
Only enables the Cancel
function for the dialog box
boxes. Enables the Configure >
FCIP Tunnel and Monitor
> Troubleshooting > FCIP
commands.
Enables all commands
and functions on the
associated dialog box
boxes. Also enables all
commands on the FCIP
Tunnels tab in the
device’s Properties dialog
box.
SAN - FICON
Management Allows you to configure
Cascade FICON Fabric
and Cascade FICON
Fabric Merge.
Also allows you to
configure block ports and
allow/prohibit matrix on
active configuration or
any offline configurations. Disables the Configure
Fabric, Merge Fabrics
commands on the
Configure > FICON menu.
Disables the
Allow/Prohibit Matrix
command from the
Configure menu and
right-click menu. Disables the Configure
Fabric, Merge Fabrics
commands on the
Configure > FICON menu.
Enables the
Allow/Prohibit Matrix
command from the
Configure menu and
right-click menu.
Disables all commands
and functions on the
Configure Allow/Prohibit
Matrix dialog box except
the Close and Help. Enables the Configure
Fabric, Merge Fabrics
commands on the
Configure > FICON menu.
Enables the
Allow/Prohibit Matrix
command from the
Configure menu and
right-click menu.
Enables all commands
and functions on the
associated dialog box
boxes.