Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 876)

824 Brocade Network Advisor SAN User Manual
53-1003154-01
Adding target disk LUNs for encryption
20
4. Select the target port from the Target Port table, then click Next.
The Select Initiator Port dialog box displays. (Refer to Figure 380 .)
FIGURE 380 Select Initiator Port dialog box
The dialog box is used to select an initiator port when configuring multiple I/O paths to a disk
LUN. The dialog box contains the following information:
• Storage Array: Displays the storage array that was selected from the LUN view prior to
launching the wizard.
• Host: The host selected from the LUN view prior to launching the wizard.
• Initiator Port table: Lists initiator ports using the following identifiers:
- Initiator Port
- Initiator Port Name
- Initiator Node Name
- Fabric
5. Select the initiator port from the Initiator Port table, then click Next.
LUN discovery is launched and a progress bar displays. There are four possible outcomes:
• A message displays indicating no LUNs were discovered. Click OK to dismiss the message
and exit the wizard.
• A message displays indicating LUNs have been discovered, but are already configured.
Click OK to dismiss the message and exit the wizard.
• A message displays indicating that the target is not in the right state for discovering LUNs.
Click OK to dismiss the message and exit the wizard.
• The Select LUN dialog box displays, which lists discovered LUNs that are available. (Refer
to
Figure 381 .)