Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 130)

78 Brocade Network Advisor SAN User Manual
53-1003154-01
Server Data backup
4
9. Backup data to a CD by completing the following steps.
NOTE
This is not recommended on a permanent basis. CDs have a limited life, and may only last a
month. An error message occurs if your Management application can no longer backup to the
disc.
a. Verify that the CD backup directory is correct (default directory is D:\Backup).
It is assumed that drive D is a CD-RW drive.
You can change the directory or use the Browse button to select another directory.
b. Install the formatted disc into the CD drive.
To backup to a writable CD, you must have CD-writing software installed. The disc must be
formatted by the CD-writing software so that it behaves like a drive.
10. Click Apply or OK.
The application verifies that the backup device exists and that the server can write to it.
For backup to a hard drive or writable CD, if the device does not exist or is not writable, an error
message displays that says you have entered an invalid device.
For backup to a network drive, if the device does not exist or you are not authorized to write to
the network drive, an error message displays that states you have entered an invalid device
path or invalid network credentials.
Click OK to go back to the Options dialog box and fix the error.
Backup occurs, if needed, at the interval you specified.
Enabling backup
Backup is enabled by default. However, if it has been disabled, complete the following steps to
enable the function.
1. Select Server > Options.
The Options dialog box displays.
2. Select Server Backup in the Category list.
3. Select the Enable Backup check box.
4. Click Apply or OK.
Disabling backup
Backup is enabled by default. If you want to stop the backup process, you need to disable backup.
To disable the backup function, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Server Backup in the Category list.