Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1277)

Brocade Network Advisor SAN User Manual 1225
53-1003154-01
Creating a custom frame monitor
30
Frame Monitoring requirements
To configure Frame Monitoring, the following requirements must be met:
• The switch must be running Fabric OS 7.0.0 or later.
• Frame Monitoring requires the Advanced Performance Monitoring license and the Fabric
Watch license.
NOTE
The Advanced Performance Monitoring license is required to configure frame monitors. The
monitoring functionality requires the Fabric Watch license.
The maximum number of frame monitors and offsets per port is platform-specific. Refer to the Flow
Vision Administrator’s Guide for more information.
Creating a custom frame monitor
Pre-defined frame monitors are already installed on switches that support Frame Monitoring. Use
this procedure if you want to create a custom frame monitor.
1. Select Monitor > Fabric Watch > Frame Monitor.
The Frame Monitor dialog box displays ( Figure 527 ).
FIGURE 527 Frame Monitor dialog box