Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 568)

516 Brocade Network Advisor SAN User Manual
53-1003154-01
Ports
12
• ==
• !=
• <
• >
• <=
• >=
• contains
• matches
4. Define a filter by entering a value that corresponds to the selected property in the Value
column.
5. Repeat steps 2 through 4 as needed to define more filters.
6. Click OK.
The Port Connectivity View dialog box displays. If filtering is already enabled, only those ports
that meet the filter requirements display. To enable the filter, select the Filter check box.
Resetting the filter
Reset immediately clears all existing definitions. You cannot cancel the reset.
To reset the Filter dialog box, complete the following steps.
1. Click the Filter link from the Port Connectivity View dialog box.
The Filter dialog box displays.
2. Click Reset.
All existing definitions are cleared automatically. You cannot cancel the reset.
Enabling the filter
To enable the filter, select the Filter check box.
Disabling the filter
To disable the filter, clear the Filter check box.