Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 693)

Brocade Network Advisor SAN User Manual 641
53-1003154-01
Switch, port, and LAG deployment
16
8. Select one or more of the following configurations, to be deployed on the selected targets.
NOTE
These configurations can be pushed to target DCB switches, FOS version 6.3.1_cee or
6.3.1_del.
For switches:
• QoS, DCB Map
• QoS, Traffic Class Map
• FCoE Map
• VLAN Classifiers and Rules
• LLDP Profiles
• 802.1x Configuration
NOTE
See “Source to target switch Fabric OS version compatibility for deployment” for restrictions.
For ports:
• Port attributes (interface mode, etc.)
• QoS, DCB Map / Traffic Class Map
• FCoE Map
• LLDP Profiles
• 802.1x Configuration
NOTE
On the Deploy to Ports dialog box, you can write port configurations to the switch by enabling
the check box at the bottom of the dialog box.
For LAGs:
• LAG attributes (Interface Mode, etc.)
• QoS, DCB Map / Traffic Class Map
• LLDP Profiles
9. Click to move the available targets selected for configuration deployment to the Selected
Targets list.
10. Click OK.
The Deployment Status dialog box launches.
11. Click Start on the Deployment Status dialog box to save the changes to the selected devices.
12. Click Close to close the Deployment Status dialog box.