Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1061)

Brocade Network Advisor SAN User Manual 1009
53-1003154-01
Editing thresholds
24
Editing thresholds
The Management application allows you to edit the name, number of events needed, and time
period of ISL Protocol, Link, and Security thresholds.
Editing a C3 Discard Frames threshold
NOTE
This threshold is only available for Fabric OS devices.
NOTE
This feature requires a Trial or Licensed version.
Use to block a port when a C3 Discard Frames violation type meets the Fabric OS switch threshold.
To edit a C3 Discard Frames threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays.
2. Select C3 Discard Frames (Fabric OS only) from the Violation Type list.
3. Select the threshold you want to change and click Edit.
The Edit C3 Discard Frames dialog box displays.
4. Complete step 4 through step 7 in “Adding a C3 Discard Frames threshold” on page 999.
5. Click OK on the Edit C3 Discard Frames Threshold dialog box.
If the threshold has already been assigned to ports, an “Are you sure you want to make the
requested changes to this threshold on “X” ports?” message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 1007.
6. Click OK on the Port Fencing dialog box.
Editing an Invalid CRCs threshold
NOTE
This threshold is only available for Fabric OS devices.
NOTE
This feature requires a Trial or Licensed version.
Use to block a port when the Invalid CRCs Threshold violation type meets the Fabric OS switch
threshold.
To edit an Invalid CRCs threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays.
2. Select Invalid CRCs (Fabric OS only) from the Violation Type list.