Port health violations widget – Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 235
Brocade Network Advisor SAN User Manual
183
53-1003154-01
Dashboard customization
6
•
Product — The product affected by this monitor. Click to launch the Product page for this
device (refer to
on page 216). When you launch the Product
page, the detailed view closes.
•
Object Name (MAPS and Fabric Watch support) — The object name (such as switch name,
port name, FRU name, and so on).
•
Fabric Name — The fabric associated with the product.
•
Rule Name (MAPS only support) — The rule name.
•
Table functions — For a description of how to use the table functionality, refer to
2. Click the close (X) button.
Port Health Violations widget
The Port Health Violations widget displays the number of violations for each product based on the
selected fabric and a specified time range. There are four port health violation widgets: All, ISL,
Initiator, and Target.
The Port Health Violations widget displays the following data for each product:
•
Severity icon/port count/widget title — The color of the worst severity and the number of
products with that severity displays before the widget title.
•
Product — A product label such as product name, IP address, node WWN, domain ID, or zone
alias.
•
Port — A port identifier such as port name, number, address, WWN, user port number, or zone
alias. Click to launch the Port Page (refer to
on page 225). When you
launch the Port page, the detailed view closes.
NOTE
All non-FC ports display either the MAC address or the port name instead of WWN.
•
Connected_Port (where Connected_Port is Connected Port, Initiator, or Target) — Displays the
address of the port:
•
Violation Count — The number of MAPS and Fabric Watch rule violations for the port.
•
CRC Errors — The number of times an invalid cyclic redundancy check error occurs on a port or
a frame that computes to an invalid CRC.
•
Invalid Tx Words — The number of times an invalid transmission word error occurs on a port.
•
Loss of sync — The number of times a synchronization error occurs on the port.
•
Link Failures — The number of times a link failure occurs on a port or sends or receives NOS.
•
Loss of Signal — The number of times that a signal loss occurs in a port.
•
Protocol Errors — The number of times a protocol error occurs on a port.
•
Link Reset — The ports on which the number of link resets exceed the specified threshold
value.
•
C3TXTO — The number of Class 3 discards frames because of timeouts.