Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1051)

Brocade Network Advisor SAN User Manual 999
53-1003154-01
Adding thresholds
24
Adding thresholds
NOTE
This feature requires a Trial or Licensed version.
The Management application allows you to create Invalid CRCs, Invalid words, Link, Link Reset,
Protocol Error, Security, and Sync Loss thresholds.
Adding a C3 Discard Frames threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
Use to block a port when a C3 Discard Frames violation type meets the Fabric OS switch threshold.
For default threshold values for Fabric OS devices, refer to Chapter 7 of the Fabric Watch
Administrator's Guide.
To add an C3 Discard Frames threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays ( Figure 453 ).
FIGURE 453 Port Fencing dialog box
2. Select C3 Discard Frames (Fabric OS only) from the Violation Type list.
3. Click Add.
The Add C3 Discard Frames Threshold dialog box displays.