Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1444)

1392 Brocade Network Advisor SAN User Manual
53-1003154-01
Upload failure data capture
34
Upload failure data capture
You can use upload failure data capture to enable, disable, and purge failure data capture files as
well as configure the FTP Host for the switch.
NOTE
Upload failure data capture is only supported on Fabric OS devices.
Enabling upload failure data capture
1. Select Monitor > Technical Support > Upload Failure Data Capture.
The Upload Failure Data Capture dialog box displays.
FIGURE 586 Upload Failure Data Capture dialog box
2. Select a one or more devices on which you want to enable automatic trace dump from the
Available Switches with Upload Failure Data Capture Disabled table.
The Available Switches with Upload Failure Data Capture Disabled table displays the following
information:
• All Levels — All discovered devices and ports as both text and icons.
• Name — The name of the available switch.
• Product Type — The type of product.
• Tag — The tag number of the device.
• Serial # — The serial number of the device.
• WWN — The switch port’s world wide name.
• IP Address — The switch port’s IP address.
• Domain ID — The switch port’s top-level addressing hierarchy of the domain.
• Vendor — The hardware vendor’s name.
• Model — The name and model number of the hardware.
• Port Count — The total number of ports.
• Firmware — The firmware version.