Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 743)

Brocade Network Advisor SAN User Manual 691
53-1003154-01
Configuring Virtual Fabrics
19
7. Click OK on the Edit Properties dialog box.
The Base Switch column in the Existing Logical Switches list now displays Yes for the logical
switch.
8. Click OK on the Logical Switches dialog box.
The Logical Switch Change Confirmation and Status dialog box displays with a list of all
changes you made in the Logical Switches dialog box.
The Re-Enable ports after moving them and QoS disable the ports while moving them check
boxes are selected by default.
NOTE
Ports are disabled before moving from one logical switch to another.
9. (Optional) Select the Unbind Port Addresses while moving them check box.
10. Click Start to send these changes to the affected chassis.
NOTE
Most changes to logical switches will disrupt data traffic in the fabric.
The status of each change is displayed in the Status column and Status area in the dialog box.
11. When the changes are complete, click Close.