Comparing maps policies – Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 1415
Brocade Network Advisor SAN User Manual
1363
53-1003154-01
MAPS actions
33
Each tab contains the following fields and components:
•
Rules list — Lists the rules defined for the selected policy.
•
Groups/Rules — Displays the default groups (under the System Groups node) and
user-defined groups (under the Custom Groups node) for the selected switch. The
available groups in the Rules table depend on the measure you selected in the Add/Edit
Threshold area. For example, if you selected an SFP measure, only SFP groups become
available. You can only configure a user-defined group on the Port and FCIP tabs. For more
information, refer to
Rules display below the appropriate group node based on rule targets.
•
Monitor Condition — A combination of the measure, time base, and threshold expression
for the rule.
•
Time Base — The duration by which to monitor the measure.
•
Actions check boxes — Actions configured for the rule. Each action has a column and each
action selected for a rule has a check mark. Supported actions include:
•
Status Marginal (switch status)
•
Status Critical (switch status)
•
RAS Log Event
•
Port Decommission
•
Fence (Port Fencing)
•
SNMP Trap
•
•
SFP Marginal (Port SFP status)
4. Click OK on the View Policy dialog box.
5. Click Close on the MAPS Configuration dialog box.
Comparing MAPS policies
You can compare any two policies across a fabric at a time. To compare MAPS policies, complete
the following steps.
1. Right-click a device in the Product List or Connectivity Map and select Fabric Vision > MAPS >
Configure.
The MAPS Configuration dialog box displays.
2. Select two policies across the fabric that you want to compare and click Compare.
The Compare dialog box displays.