Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1336)

1284 Brocade Network Advisor SAN User Manual
53-1003154-01
Event action definitions
32
• < – Less than
• > – Greater than
• >= – Greater than or equal to
• <= – Less than or equal to
• In – Matches collection
• Not_in – Does not match collection
• ~ – Arbitrary Unicode regular expression
5. Enter the value of the varbind. The value you enter must conform to the data type required by
the varbind. For example, if the varbind expects an integer and you enter a text string, your
entry will be rejected. Alternatively, you can select values from drop-down lists, shown in
Figure 552 .
6. Click Next.
The Sources pane of the Add Event Action dialog box displays. Proceed to “Selecting source
address products and ports” .
Selecting source address products and ports
The Sources pane of the Add Event Action dialog box, shown in Figure 553 , allows you to enter the
IP address, the world wide name, or the name of the source to use as event senders. Alternatively,
you can select source address products to use as event senders from the available list of sources.
You can select from the available list of SAN products, IP products, or hosts by selecting the
appropriate tab.
FIGURE 553 Sources pane of the Add Event Action dialog box
To configure the identity of the event action source, complete the following steps.
1. Select Monitor > Event Processing > Event Actions.
The Event Actions dialog box displays.