Configuring an hourly deployment schedule, Configuring a one-time deployment schedule – Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 718
666
Brocade Network Advisor SAN User Manual
53-1003154-01
Security configuration deployment
17
10. Choose one of the following options to configure the frequency at which deployment runs for
the schedule:
•
To configure deployment to run only once, refer to
“Configuring a one-time deployment
•
To configure hourly deployment, refer to
“Configuring an hourly deployment schedule”
•
To configure daily deployment, refer to
“Configuring a daily deployment schedule”
•
To configure weekly deployment, refer to
“Configuring a weekly deployment schedule”
•
To configure monthly deployment, refer to
“Configuring a monthly deployment schedule”
11. Click OK on the Schedule Properties dialog box.
12. Select one or more ports or products to which you want to deploy the configuration in the
Available Targets list and click the right arrow button to move them to the Selected Targets list.
13. Click OK on the Deploy to Products - Layer 2 ACL dialog box.
Configuring a one-time deployment schedule
To configure a one-time schedule, complete the following steps.
1. Select One Time from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click the Date list to select a date from the calendar.
To configure security configuration schedule, refer to
Configuring an hourly deployment schedule
To configure an hourly schedule, complete the following steps.
1. Select Hourly from the Frequency list.
2. Select the minute past the hour you want deployment to run from the Minutes past the hour
list.
Where the minute value is from 00 through 59.