Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1402)

1350 Brocade Network Advisor SAN User Manual
53-1003154-01
MAPS actions
33
• Switch Status Critical — Use to set the switch status to critical
• Switch Status Marginal. — Use to set the switch status to marginal.
For a complete list of categories and the associated measures and actions, refer to “MAPS
categories, measures, and actions” on page 1335.
4. Click OK on the MAPS Policy Actions dialog box.
5. Click Close on the MAPS Configuration dialog box.
Configuring e-mail notification
In environments where it is critical that you are notified about errors quickly, you can use e-mail
notifications. With e-mail notifications, you can be notified of serious errors by e-mail, text
message, or pager, so you can react quickly.
1. Right-click a device in the Product List or Connectivity Map and select Fabric Vision > MAPS >
Configure.
The MAPS Configuration dialog box displays.
2. Select an object in the MAPS policies list and click E-mail Setup.
Select All Fabrics to configure e-mail notification for all policy rules for all MAPS-enabled
devices in all fabrics.
Select one or more fabrics to configure e-mail notification for all policy rules on all
MAPS-enabled devices in the selected fabrics.
Select one or more devices to configure e-mail notification for all policy rules on the selected
devices.
The MAPS E-Mail Setup dialog box displays. This dialog box enables you to configure e-mail
notification for all policy rules on a device.
3. Enter one or more addresses in the E-mail address text box.
You can enter up to 5 addresses, separated by semi-colons. E-mail addresses are logical
switch specific, not physical chassis specific. You can configure different e-mail addresses for
different logical switches in the same physical chassis.
To send a text message or page via e-mail, use the following format [email protected],
where number is your phone number and carrier.com is the SMS server. For example,
[email protected] (text message) or [email protected] (page).
NOTE
Check with your carrier for the exact e-mail address.
4. Enter the IP address of the relay host in the Relay Host field.
Relay host is a physical chassis setting. This setting affects all logical switches in the physical
chassis.