Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1297)

Brocade Network Advisor SAN User Manual 1245
53-1003154-01
Adding a configuration policy manager
31
a. Select the Check for redundant connections to attached fabrics check box to determine if
there are at least the minimum number of configured physical connections between the
host and the attached fabric.
The default is 2. For more information about this check and a fix for rule violations, refer to
“Host configuration policy managers” on page 1235.
b. Enter the minimum number of connections between the host and the attached fabric in
the Minimum Connections field.
The default is 2.
c. Select the Check for connections through two fabrics to each target LUN check box to
determine if there are redundant connections between the host group and the target LUN.
For more information about this check and a fix for rule violations, refer to “Host
configuration policy managers” on page 1235.
d. Select the hosts to which you want to apply this policy in the Available Hosts list and click
the right arrow button.
NOTE
You can use the All Host target in the Available Hosts list for future provisioning. Select All
Hosts and click the right arrow button to apply this policy to all discovered hosts.
The selected hosts display in the Selected Hosts list.
9. To set configuration policy managers for the Management application ( Figure 533 ), complete
the following steps.
FIGURE 533 Add Configuration Policy Manager dialog box, Management Checks tab
a. Select the Management Checks tab.
b. Select the Check to see if the server backup is enabled and working check box to
determine the following configurations:
• Backup enabled for the Management application server.
• Backup output directory is accessible and writable.
This policy only applies to scheduled backup, not manual (on demand) backup.
For more information about this check and a fix for rule violations, refer to “Management
configuration policy manager” on page 1237.
10. Click OK on the Add Monitor dialog box.
The Configuration Policy Manager dialog box displays with the new configuration policy
manager in the Monitors list.
11. Click Close on the Configuration Policy Manager dialog box.