Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 832)

780 Brocade Network Advisor SAN User Manual
53-1003154-01
Creating a new encryption group
20
Configuring key vault settings for HP Enterprise Secure Key Manager
(ESKM/SKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
“Creating a new encryption group”
on page 764.
Figure 331 shows the key vault selection dialog box for ESKM/SKM.
FIGURE 331 Select Key Vault dialog box for ESKM/SKM
1. Enter the IP address or host name for the primary key vault.
2. Enter the name of the file that holds the primary key vault’s CA key certificate, or browse to the
desired location.
3. Enter the password you established for the Brocade user group.
4. If you are using a backup key vault, enter the IP address or host name, and the name of the file
holding the backup key vault’s public key certificate in the fields provided. The same user
name and password used for the primary key vault are automatically applied to the backup
key vault.
5. Click Next.
The Specify Certificate Signing Request File Name dialog box displays. (Refer to Figure 332 .)