Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 934
882
Brocade Network Advisor SAN User Manual
53-1003154-01
Viewing and editing encryption group properties
20
NOTE
If groups are not visible in the Encryption Center Devices table, select View > Groups from the
menu task bar.
3. Click Add.
The Add Tape Pool dialog box displays. (Refer to
.) The Name tape pool label type is
the default; however, you can change the tape pool label type to Number (Refer to
.)
FIGURE 418
Add Tape Pool by name dialog box
FIGURE 419
Add Tape Pool by number dialog box
4. Based on your selection, do one of the following:
•
If you selected Name as the Tape Pool Label Type, enter a name for the tape pool. This
name must match the tape pool label or tape ID that is configured on the tape
backup/restore application.
•
If you selected Number as the Tape Pool Label Type, enter a (hex) number for the tape
pool. This number must match the tape pool label or tape number that is configured on
the tape backup/restore application.
5. Select the Encryption Mode. Options are Clear Text, DF-Compatible Encryption, and Native
Encryption. Note the following:
•
DF-Compatible Encryption is valid only when LKM/SSKM is the key vault.
•
The Key Lifespan (days) field is editable only if the tape pool is encrypted.
•
If Clear Text is selected as the encryption mode, the key lifespan is disabled.
NOTE
You cannot change the encryption mode after the tape pool I/O begins. DF-compatible
encryption requires a DF-compatible encryption license to be present on the switch. If the
license is not present, a warning message displays.