Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 669)

Brocade Network Advisor SAN User Manual 617
53-1003154-01
DCB configuration
16
5. When you have finished configuring the policies, apply the settings to the DCB port.
NOTE
Clicking Cancel when there are pending changes launches a pop-up dialog box.
6. Click OK when you have finished modifying the DCB port parameters.
The Deploy to Ports dialog box displays.
7. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box launches.
8. Click Start on the Deployment Status dialog box to save the changes to the selected port or
ports.
9. Click Close to close the Deployment Status dialog box.
Editing a LAG
Use the following procedure to change members and policies in a link aggregation group (LAG).
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select the link aggregation group (LAG) from the Products/Ports list.
3. Click Edit.
The Edit LAG dialog box displays, as shown in Figure 237 .
FIGURE 237 Edit LAG dialog box