Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 861)

Brocade Network Advisor SAN User Manual 809
53-1003154-01
High availability clusters
20
Creating HA clusters
For the initial encryption node, perform the following procedure.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 266 on page 694.)
2. Select an encryption group from the Encryption Center Devices table, then select Group >
HA Cluster from the menu task bar.
NOTE
If groups are not visible in the Encryption Center Devices table, select View > Groups from the
menu task bar.
The Encryption Group Properties dialog box displays, with the HA Clusters tab selected. (Refer
to
Figure 366 .)
3. Select an available encryption engine from the Non HA Encryption Engines table and a
destination HA cluster from the High Availability Clusters table. Select New HA Cluster if you are
creating a new cluster.
NOTE
If you are creating a new HA cluster, a dialog box displays requesting a name for the new HA
cluster. HA cluster names can have up to 31 characters. Letters, digits, and underscores are
allowed.
4. Click the right arrow to add the encryption engine to the selected HA cluster.
FIGURE 366 Encryption Group Properties dialog box - HA Clusters tab
To add the second encryption node to the HA cluster, perform the following procedure.
1. Select the desired HA cluster from the right panel.
2. Select the desired encryption engine to be added from the left panel.