Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 600)

548 Brocade Network Advisor SAN User Manual
53-1003154-01
Port Auto Disable
12
• Port # — Displays the port number.
• Port WWN — Displays the port world wide name.
• Port Name — Displays the port name.
• User Port # — Displays the user port number.
• PID — Displays the port identifier.
• Connected Port # — Displays the connected port number.
• Connected Port WWN — Displays the connected port world wide name.
• Connected Port Name — Displays the connected port name.
5. Click OK on the Port Auto Disable dialog box.
Configuring Port Auto Disable event triggers
NOTE
To configure the specific events that trigger the Port Auto Disable, the device must be running Fabric
OS 7.0 or later.
You can configure a port to become blocked when one or more of the following events occur on the
configured port:
• Loss of Sync
• Loss of Signal
• OLS (Offline Primitive Sequence)
• NOS (Not Operational Primitive Sequence)
• LIP (Loop Initialization Primitive Sequence)
To configure the PAD event triggers, complete the following steps.
1. Select Monitor > Port Auto Disable.
The Port Auto Disable dialog box displays.
2. Select the fabric on which you want to configure the PAD event triggers from the Fabric list.
3. Select All Ports from the Show list to filter the port list:
4. Select one or more ports or devices on which you want to configure the PAD event triggers.
5. Click Edit.
The Edit Configuration dialog box displays.
6. Select one or more of the following event triggers:
• Loss of Sync
• Loss of Signal
• OLS (Offline Primitive Sequence)
• NOS (Not Operational Primitive Sequence)
• LIP (Loop Initialization Primitive Sequence)
7. Click OK on the Edit Configuration dialog box.
8. Click OK on the Port Auto Disable dialog box.