Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1131)

Brocade Network Advisor SAN User Manual 1079
53-1003154-01
SAN historical performance data
28
Enabling SAN-wide historical performance collection
To enable historical performance collection, select Monitor > Performance > Historical Data
Collection.
The Fabric Selector dialog box displays with Enable SAN Wide enabled by default. This enables
historical performance data collection for all fabrics in the SAN.
NOTE
After enabling historical data collection, information for switches, ports, and FCIP tunnels also
displays in the IP Historical Graph/Tables dialog box. If available, click the IP tab, then select Monitor
> Performance > Historical Graphs/Tables.
Enabling historical performance collection for selected fabrics
To enable historical performance collection for selected fabrics, complete the following steps.
1. Select Monitor > Performance > Historical Data Collection.
The Fabric Selector dialog box displays.
2. Select Enable Selected.
The Historical Data Collection dialog box displays, as shown in Figure 476 on page 1079.
FIGURE 476 Historical Data Collection dialog box
3. Select the fabrics for which you want to collect historical performance data in the Available list.
NOTE
Devices with 10GE ports must be running Fabric OS 6.4.1 or later to obtain the correct TE_Port
statistics (TX/RX).
NOTE
Devices with 10GE ports must have the RMON MIB enabled on the switch. For more
information about the rmon collection command, refer to the Fabric OS Converged Enhanced
Ethernet Command Reference.
4. Click the right arrow to move the selected fabrics to the Selected list.