Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 662)

610 Brocade Network Advisor SAN User Manual
53-1003154-01
DCB configuration
16
7. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box displays.
8. Click Start on the Deployment Status dialog box to save the changes to the switch.
9. Click Close to close the Deployment Status dialog box.
Configuring the DCB interface with the DCB map and global LLDP profile
To configure the DCB interface, complete the following steps.
1. Select Configure > DCB.
The DCB Configuration dialog box displays.
2. Select the Te port connected to the CNA from the Product/Ports list and click Edit..
The Edit Port dialog box displays, as shown in Figure 236 .
3. Select the Port tab, if necessary, and select the Enable check box.
4. Select L2 from the Interface Mode list.
5. Select Converged (for a Brocade CNA) or Access (for a QLogic CNA) from the L2 Mode list.
6. Click the QoS tab and select the Assign a map check box.
7. Select DCB from the Map Type list.
8. Select the DCB map you created in “Creating a DCB map to carry the LAN and SAN traffic” on
page 607 from the Available DCB Maps list.
9. Click the LLDP-DCBX tab and select the Enable LLDP-DCBX on Te Port Number check box.
10. Select Assign the Global Configuration.
11. Click OK.
The Deploy to Ports dialog box displays.
12. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box displays.
13. Click Start on the Deployment Status dialog box to save the changes to the selected ports.
14. Click Close to close the Deployment Status dialog box.
Creating the FCoE VLAN to carry FCoE traffic
NOTE
You can complete this procedure using the Management application on embedded platforms such
as the Fabric OS converged 10 GbE switch module for the IBM BladeCenter or the Dell M8428-k
switch. You must use Web Tools to complete this procedure for the Fabric OS Fabric OS switch or the
FCOE10-24 port blade.
To create the FCoE VLAN, complete the following steps. This procedure is applicable for Fabric OS
versions earlier than Fabric OS 7.0.
1. Select the Fabric OS FCoE switch in the device tree.
2. Select Configure > Element Manager > Admin.