Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 679)

Brocade Network Advisor SAN User Manual 627
53-1003154-01
FCoE provisioning
16
Changing the VLAN ID on the default FCoE map
You can change the VLAN ID on the default FCoE map only when no ports or LAGs are participating
as members of the switch. You must first manually remove the FCoE map option for each of the
port members before you change the VLAN ID on the switch.
NOTE
You can complete this procedure using the Management application on embedded platforms such
as the Fabric OS converged 10 GbE switch module for the IBM BladeCenter or the Dell M8428-k
switch. You cannot perform this task on the Fabric OS Fabric OS switch or the FCOE10-24 port blade.
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a switch and click Edit.
3. Click the FCoE tab on the Edit Switch dialog box.
The Edit Switch dialog box, FCoE tab displays the following FCoE map parameters:
NOTE
The FCoE tab does not display for the Fabric OS Fabric OS switch or the FCOE10-24 port blade.
• Name — The name of the FCoE map that will be available for assignment to ports on this
switch. This is a read-only field.
• VLAN ID — Enter an FCoE VLAN identifier to associate with the FCoE map. The values range
from 2 through 3583, and 1002 is the default.
• DCB Map — The DCB map that is associated with the FCoE map. This is a read-only field.
4. Accept the default VLAN ID of 1002, or change the value. The valid VLAN ID range is from 2
through 3583.
5. Click the right arrow button to move the FCoE map parameters into the FCoE Maps list.
6. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box.
7. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box displays.
8. Click Start on the Deployment Status dialog box to save the changes to the selected devices.
Enabling or disabling the FCoE map on the port
You must first manually disable an FCoE map-enabled port if you want to edit the VLAN ID of the
FCoE map. Refer to
“Changing the VLAN ID on the default FCoE map” on page 627 for information
on editing the VLAN ID using the Edit Switch dialog box, FCoE tab.
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a port and click Edit.