Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 868)

816 Brocade Network Advisor SAN User Manual
53-1003154-01
Configuring encryption storage targets
20
NOTE
You must enter the host node world wide name before clicking Add, to add the WWN to the
Selected Hosts table.
• Node WWN text box: Type a world wide name for a host node.
NOTE
You must also enter the host port world wide name before clicking Add to add the node
WWN to the Selected Hosts table.
• Device Type: The device type indicated by the fabric’s name service. The value is either
Initiator or Initiator + Target.
• Right arrow button: Moves a host from the Host in Fabric table to the Selected Hosts table.
• Left arrow button: Removes a host from the Selected Hosts table.
• Add button: Click to manually add host port world wide names or host node world wide
names to the Selected Hosts table.
8. Select hosts using either of the following methods:
a. Select a maximum of 1024 hosts from the Hosts in Fabric table, then click the right arrow
to move the hosts to the Selected Hosts table. (The Port WWN column contains all target
information that displays when using the nsshow command.)
b. Manually enter world wide names in the Port WWN and Node WWN text boxes if the hosts
are not included in the table. You must fill in both the Port WWN and the Node WWN. Click
Add to move the host to the Selected Hosts table.
9. Click Next.
The Name Container dialog box displays. (Refer to Figure 372 .) You can specify a name for the
target container that is created in the encryption engine to hold the target configuration data.
The name is only needed when configuring the storage using the command line interface (CLI).
The container name defaults to the target WWPN. You can, however, rename the container
name. Target container names can have up to 31 characters. Letters, digits, and underscores
are allowed.