Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 703)

Brocade Network Advisor SAN User Manual 651
53-1003154-01
Virtual FCoE port configuration
16
• There is a dynamic binding between the virtual FCoE port and the physical port or LAG.
• There is a static binding between the virtual FCoE port and the physical port or lag and there
are end devices connected to it.
To view the virtual FCoE ports, complete the following steps:
1. Select Configure > FCoE from the menu bar.
or
Right-click the DCB device and select FCoE.
The FCoE Configuration dialog box displays.
2. Select the Virtual FCoE Ports tab.
The Virtual FCoE Ports tab displays, as shown in Figure 252 .
FIGURE 252 Virtual FCoE Ports dialog box
3. Select one or more virtual ports from the Ports list.
4. Perform one of the following tasks:
• Click Enable to enable a selected virtual FCoE port from the Virtual FCoE Ports tab.
• Click Disable to disable a selected virtual FCoE port from the Virtual FCoE Ports tab.
• Click Connected Devices to view a list of FCoE virtual ports and to what they are directly
connected.
5. Click Close to close the dialog box.