Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 519)

Brocade Network Advisor SAN User Manual 467
53-1003154-01
SMI Agent Configuration Tool
11
CIMOM tab
NOTE
You must have SAN - SMI Operation Read and Write privileges to view or make changes on the
CIMOM tab. For more information about privileges, refer to
“User Privileges” on page 1451.
The CIMOM tab enables you to configure the CIMOM server port, the CIMOM Bind Network
Address, and the CIMOM log.
Configuring the SMI Agent port number
To configure the SMI Agent port number, complete the following steps.
1. Click the CIMOM tab.
FIGURE 191 CIMOM tab
2. Select or clear the Enable SSL check box, to enable or disable SSL for the SMI Agent.
NOTE
Disabling SSL will disable Indication and Client Mutual Authentication.
If the check box is checked (default), SSL is enabled. If the check box is clear, SSL is disabled.
3. Enter the SMI Agent port number in the SMI Agent Port # field.
This port number must be within the range of 1 through 65535. Defaults are 5989 with SSL
enabled and 5988 with SSL disabled.