Disabling fabric binding – Brocade Network Advisor SAN User Manual v12.3.0 User Manual

Page 1040

Advertising

988

Brocade Network Advisor SAN User Manual

53-1003154-01

Fabric Binding overview

2. In the Fabric List table, select the Enable/Disable check box for fabrics for which you want to

configure fabric binding.

For instructions on adding and removing switches from the membership list, refer to

“Adding

switches to the fabric binding membership list”

on page 989 and

“Removing switches from

fabric binding membership”

on page 990.

3. Click OK on the Fabric Binding dialog box.

The Fabric Binding Status dialog box displays with the following information:

•

Fabric Name — Displays the enabled fabric name selected for fabric binding.

•

Applying Fabric Binding Changes for selected fabric message — Displays the status of the
fabric binding changes.

•

Setting SCC Policy message — The Switch Connection Control (SCC) policy prevents
unauthorized devices from joining a fabric.

•

Setting FWCP Policy message — Fabric-wide consistency is necessary for FICON switch
binding.

•

List of possible reasons that could cause Fabric Binding failure message — Refer to the
Fabric OS Administrator’s Guide for detailed information.

Disabling fabric binding

Fabric binding cannot be disabled while High Integrity Fabric (HIF) is active if the switch is offline.
This disables fabric binding and High Integrity Fabric on the switch, but not the rest of the fabric.
Disabled switches segment from the fabric.

NOTE

Fabric binding is only supported on Fabric OS 5.2 or later.

1. Select Configure > Fabric Binding.

The Fabric Binding dialog box displays (

Figure 450

2. In the Fabric List table, clear the Enable/Disable check box for fabrics for which you want to

disable fabric binding.