Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1161)

Brocade Network Advisor SAN User Manual 1109
53-1003154-01
Thresholds and event notification
28
FIGURE 486 Edit Threshold Policy dialog box
3. To add a new policy, perform the following steps.
a. Click Add.
The New Threshold Policy dialog box displays as shown in Figure 487 on page 1109.
FIGURE 487 New Threshold Policy dialog box
b. Enter a name for the policy (100 characters maximum) in the Name field.
4. Select a policy type from the Policy Type list.
You can only define policies for E_Port and F_Port, and FL_Ports.
5. Select a measure from the Measure list.
You can only define policies for the Tx % Utilization and Rx % Utilization measures. You cannot
add the same measure more than once. If you try to add another threshold with the same
measure, the new values overwrite the older threshold values in the Selected Thresholds list.
6. Enter a percentage for the upper boundary in the High Boundary field.
When the counter value exceeds high boundary, an event is raised.
7. (Fabric OS only) Enter a percentage for the lower boundary in the Low Boundary field.
When the counter value goes below the low boundary, an event is raised.
8. (Fabric OS only) Enter a percentage for the buffer in the Buffer Size field.