Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1320)

1268 Brocade Network Advisor SAN User Manual
53-1003154-01
SNMP traps
32
FIGURE 542 Event Reception dialog box - Trap Credentials tab
By default, the Management application receives SNMP v1 and v2c traps from IronWare OS and
Network OS IP products that have any SNMP community strings. You can accept or restrict SNMP
v1 and v2c traps by selecting one of the following check boxes in the Event Reception dialog box:
• Do not accept SNMP v1/v2c traps
Use this option to turn off receiving SNMP v1 and v2c traps.If selected, the Management
application will not receive any SNMP v1 and v2c traps.
• Accept SNMP v1/v2c traps with any community string
Use this option to turn on receiving SNMP v1 and v2c traps with any community string.
• Accept SNMP v1/v2c traps with only these community strings
Use this option to turn on receiving SNMP v1 and v2c traps with only the specified
community strings.
The Management application can receive SNMP v1 traps from Fabric OS SAN switches and
directors that have any SNMP community strings. It can receive SNMP v3 traps and informs from
these SAN products.
Table 106 explains the combinations of security and authentication, which will help you when you
make your SNMP credentials configuration decisions.