Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1196)

1144 Brocade Network Advisor SAN User Manual
53-1003154-01
Flow Monitor
29
22. Select OK to save the definition.
When the flow definition activates, the Flow Vision dialog box displays with the new flow
selected (highlighted) in the Flow Definitions table. To review the sub-flow data for the selected
flow (refer to
“Monitoring a Flow Monitor flow” on page 1149").
Selecting the target switch from a list of Fabric Vision-capable switches
To change target switch for the flow definition, complete the following steps.
1. Click the ellipses button to the right of the Target Switch field.
The Select Switch dialog box displays with all Fabric Vision-capable switches listed in the
Available Switches list.
2. Select the Expand All check box to expand the Group/Product tree to show all Fabric
Vision-capable devices.
3. Select a switch in the Available Switches list and click the right arrow to move to the Selected
Switch list.
Move the switch back to the Available Switches list by clicking the left arrow.
4. Click OK on the Select Switch dialog box.
The selected switch displays in the Target Switch field.
Selecting an end device port from a list of available device ports
To select the port for the source or destination device, complete the following steps.
1. Click the ellipses button to the right of the Source or Destination field.
The Select Device Port dialog box displays expanded to display all supported device ports for
the target switch in the Available Device Ports list.
Unsupported ports do not display in the Available Device Ports list.
2. Select one of the following options to display either ports in specific zones or available fabrics,
devices, and ports for selection.
• Select Products and Ports from the Show list to display available fabrics, devices, and
ports as in
Figure 498 .
• Select Zones from the Show list to display available ports under specific zones as shown in
Figure 499 .