Reverting to the default background color – Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 437
Brocade Network Advisor SAN User Manual
385
53-1003154-01
SAN topology layout
8
FIGURE 167
Choose a background color dialog box
3. Select a color from the swatches tab and click OK.
•
To specify a color based on hue, saturation, and value, click the HSV tab. Specify the hue
(0 to 359 degrees), saturation (0 to 100%), value (0 to 100%), and transparency (0 to
100%).
•
To specify a color based on hue, saturation, and lightness, click the HSL tab. Specify the
hue (0 to 360 degrees), saturation (0 to 100%), lightness (0 to 100%), and transparency (0
to 100%).
•
To specify a color based on values of red, green, and blue, click the RGB tab. Specify the
values for red (0 to 255), green (0 to 255), blue (0 to 255), and alpha (0 to 255) or enter a
color code in the Color Code field.
•
To specify a color based on values of cyan, magenta, yellow, and black, click the CMYK tab.
Specify the values for cyan (0 to 255), magenta (0 to 255), yellow (0 to 255), black (0 to
255), and alpha (0 to 255).
4. Select the Set as Default Color check box.
5. Click OK to change the background color on the topology.
6. Click OK on the Map Display Properties dialog box.
Reverting to the default background color
To revert back to the default background color, complete the following steps.
1. Right-click a group and select Map Display.
The Map Display Properties dialog box displays.
2. Select the Default option.
3. Click OK on the Map Display Properties dialog box.