Yaskawa Matrix Converter - Manual (Page 295)

6
-130
Select READ Permitted
Avoid overwriting the data stored in EEPROM in the digital operator by mistake. With o3-02 set to 0, if you
set o3-01 to 1, and perform the write operation, PrE will be displayed on the digital operator, and the write
operation will be stopped.
„ Writing Parameter Set Values Stored in the Digital Operator to the MxC (COPY)
Follow the instructions below to write parameter setting stored in the digital operator to the MxC.
During the copy operation, errors may occur. If an error is displayed, press any key to cancel the error display
and return to the o3-01 display.
Tried to write parameters to EEPROM on the digital operator, but unable to perform
write operation.
Table 6.2 COPY Function Procedure
Step
No.
Digital Operator Display Explanation
1 Press the MENU key, and select Advanced Programming Mode.
2 Press the DATA/ENTER key, and select the parameters monitor display.
3 Display o3-01 (Copy Function Selection) using the up and down arrow keys.
4 Press the DATA/ENTER key, and select the parameters setting display.
5 Change the set value to 2 using the up arrow key.
6 Set the changed data using the DATA/ENTER key. The COPY function will start.
7
If the COPY function ends normally, “COPY COMPLETE” is displayed on the
digital operator.
8 The display returns to o3-01 when a key is pressed.
Error Display Meaning
RDE
DATA ERROR
** Main Menu **
-ADV-
Programming
Initialization
-ADV-
A1 - 00=1
Select Language
COPY Function
-ADV-
o3 - 01=0
Copy Funtion Sel
Copy Funtion Sel
-ADV-
o3-01= 0
COPY SELECT
*0*
Copy Funtion Sel
-ADV-
o3-01= 2
OP →MxC WRITE
*0*
COPY
-ADV-
OP →MxC COPYING
COPY
-ADV-
COPY COMPLETE
Copy Funtion Sel
-ADV-
o3 - 01 =0
COPY SELECT
*0*