Yaskawa Matrix Converter User Manual
Page 363
Advertising
8
-16
3. Loosen the mounting screws (1) on the left and right sides of the control terminals until the terminals are
free. These screws do not have to be completely removed. They are self-rising.
4. Pull out the terminal board sideways (as indicated by the large arrow) with the screws sticking out from the
board.
Installation
Follow the steps used to remove the terminal board but in reverse order.
Before inserting the board, make sure that the pin for the CN8 connector on the control board is correctly posi-
tioned with the terminal board.
The connector pins may be bent if the board is forced into place, and possibly prevent the MxC from operating
correctly.
Fixing screws (2) of control terminals
T U V
R P
4. 5. 6. 76 86 96
(CN8)
Advertising