Yaskawa Matrix Converter - Manual (Page 297)

6
-132
An error may occur during the comparison. If an error is displayed, press any key to cancel the error display
and return to the o3-01 display. Error displays and their meanings are shown below. (Refer to Chapter 7
Errors when Using Digital Operator Copy Function.)
„ Application Precautions
When using the copy function, check that the following settings are the same between the MxC and the digital
operator.
• If using the copy function, make sure communications are off-line or the option card has been removed.
• If the power supply of the MxC is turned off while executing the copy function, a CPF03 fault (EEPROM
error) will occur.
6
Set the changed data using the DATA/ENTER key. The VERIFY function will
start.
7
If the VERIFY function ends normally, “VERIFY COMPLETE” appears on the
digital operator.
8 The display returns to o3-01 after any key is pressed.
Error Display Meaning
Verify error (Settings in the digital operator and the MxC do not match).
• MxC product and type • MxC capacity and voltage
• Software number • Control method
Table 6.3 VERIFY Function Procedure (Continued)
Step
No.
Digital Operator Display Explanation
VERIFY
-ADV-
DATA VERIFYING
VERIFY
-ADV-
VERIFY COMPLETE
Copy Funtion Sel
-ADV-
o3 - 01 =0
COPY SELECT
*0*
VYE
VERIFY ERROR