Bayer HealthCare Rapidlab 800 - Manual (Page 102)

2Ć4 Rapidlab 800 Operator's Manual
If the system detects bubbles when the sample is in the measurement module, the
Bubbles Detected in Sample message box appears. Look at the sample in the
measurement module to see where the bubble is located because bubbles may
affect the results of all the measured parameters.
Press . . . To . . .
Report Results continue with analysis. The report prints with the message, Bubbles
Detected in Sample.
Cancel stop analysis. The system starts a wash and returns to the Ready
screen.
Accepting LIS Assay Orders
An LIS can send an order to perform a patient sample or QC sample analysis. If
your system is connected to a laboratory or hospital information system or a data
management system, you may see a message box prompting you to begin a patient
sample assay.
The information system can also send a disable sampling order to the
800 system. A disabled sampling order appears in a message box when
the 800 system is in the Analyze mode.
If you want to . . . Then . . .
perform the assay follow the instructions in the message box.
cancel the order press Cancel .
Sending Results
If your system is connected to a laboratory or hospital information system or a
data management system and Auto Send is on, patient sample and QC sample
results are automatically sent to the external system. If Auto Send is off, you can
perform one of the following tasks when patient or QC analysis is complete:
Press . . . To . . .
Send transmit results.
Do Not Send prevent transmission of results.