Bayer HealthCare Rapidlab 800 - Manual (Page 525)

DĆ5 Connecting to External Devices
To prevent electrical shock and damage to either system, disconnect
the 800 system and the data management system from the AC power source before
installing the cable. Refer to Shutting Down and Restarting the System in Section 5
for the procedure to disconnect the 800 system.
1. Disconnect the 800 system from the AC power source.
2. Disconnect the computer for the data management system from the AC power
source.
3. Connect the interface cable to serial port 2 or 3 on the 800 system and to the
Bayer Diagnostics data management system. Refer to Figure D-1.
4. Tighten the hold down screws on the connectors.
5. Restore power to the 800 system and the computer for the data management
system.
6. Refer to Configuring for External Devices in Section 5 to configure the 800
system for the data management system.
Connecting to a Line Printer
Use this procedure to connect an 800 system to a line printer.
Materials Required:
S printer to 800 system interface cable for a parallel port (supplied with printer)
To prevent electrical shock and damage to either instrument,
disconnect the 800 system and the printer from the AC power source before
installing the cable. Refer to Shutting Down and Restarting the System in Section 5
for the procedure to disconnect the 800 system.
1. Disconnect the 800 system from the AC power source.
2. Disconnect the printer from the AC power source.
3. Connect the interface cable to the line printer and to the parallel port on the
800 system. Refer to Figure D-1.
4. Restore power to the 800 system and to the line printer.
5. Refer to Configuring for External Devices in Section 5 to configure the 800
system for the line printer.
WARNING
WARNING