Bayer HealthCare Rapidlab 800 - Manual (Page 594)

HĆ2 800 Series Operator's Manual
2. Inspect the packing case and report any damage to the shipper. Notify your
Bayer Diagnostics representative at installation.
3. Cut the shipping straps and open the packing case.
4. Remove the installation tray and set it aside.
5. Carefully lift the packing case up and off of the system. If you anticipate
relocating your system, do not discard the packing case.
6. Place the system on a level work surface, with the rear panel accessible.
7. Remove any tape and protective packing material from the system.
8. Unpack the installation tray and check the contents against the printed list
included in the box.
9. Open the system:
a. Turn the fasteners one-half turn to the left with a Phillips screwdriver.
b. Lift the top of the system up and secure the hinges.
10. Inspect PC boards and cables:
a. Remove the card cage cover.
b. Ensure that the PC boards are seated properly.
c. Ensure that all of the cables are connected.
11. Close the system:
a. Release the hinges.
b. Turn the fasteners one-half turn to the right with a Phillips screwdriver.
12. Install the optional bar code scanner:
a. Remove the bar code scanner from the shipping carton.
b. Connect the bar code scanner to the bar code scanner port on the rear panel
as shown in Figure H-1.