Lenze 8400 HighLine - Manual (Page 1069)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
1069
15 Parameter reference
15.2 Parameter list | C01221
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01221
C01222
Parameter | Name:
C01221 | MCK: Ref. mode
Data type: UNSIGNED_8
Index: 23354
d
= 5B3A
h
Selection of the homing mode.
 Homing
Selection list (Lenze setting printed in bold) Info
4 >_Rp_<_TP Positive direction - reversing on pre-stop mark (pos.
edge) - to touch probe
• From version 14.00.00
5 <_Rp_>_TP Negative direction - reversing on pre-stop mark (pos.
edge) - to touch probe
• From version 14.00.00
6 >_Rn_>_TP Positive direction - via pre-stop mark (neg. edge) -
continuing in positive direction - to touch probe
7 <_Rn_<_TP Negative direction - via pre-stop mark (neg. edge) -
continuing in negativee direction - to touch probe
8 >_TP Positive direction - to touch probe
9 <_TP Negative direction - to touch probe
10 >_Lp_<_TP Positive direction - reversing on pos. limit switch - to
touch probe
11 <_Ln_>_TP Negative direction - reversing on neg. limit switch - to
touch probe
12 >_Lp Positive direction - to pos. limit switch
13 <_Ln Negative direction - to neg. limit switch
14 >_Mlim Positive direction towards torque limit ( C01222 )
15 <_Mlim Negative direction towards torque limit ( C01222 )
100 SetRef Direct acceptance and setting of the home position
• The measuring system is set based on the home
position parameterised in C01227/2 when the drive is
at standstill.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01222 | MCK: Ref. M limit mode 14/15
Data type: INTEGER_16
Index: 23353
d
= 5B39
h
Torque limit for homing modes 14 and 15 (homing towards positive stop)
• 100 % ≡ maximum torque ( C00057 )
 Homing
Setting range (min. value | unit | max. value) Lenze setting
0.00 % 199.99 10.00 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100