Lenze 8400 HighLine - Manual (Page 66)

3 Commissioning
3.8 Commissioning of the "Table positioning" technology application
66
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Commissioning steps
Below find a description of the commissioning steps of the "Table positioning" application shown in
illustration [3-2] .
Please observe the sequence of the steps in the following chapters and follow them through
carefully. This will help you to commission your controller quickly and as safely as possible:
 Prepare controller for commissioning ( 67)
 Creating an »Engineer« project & going online ( 68)
 Parameterising the motor control ( 69)
 Parameterise application ( 70)
 Saving parameter settings safe against mains failure ( 78)
 Enable controller and test application ( 78)