Lenze 8400 HighLine - Manual (Page 248)

5 Motor control (MCTRL)
5.9 Servo control (SC)
248
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Note!
Exchange of devices
When devices with a parameterised servo control for asynchronous motors are
exchanged, problems regarding the control quality may occur if motor parameters set
for a device lower than version 11.00.00 are transferred to a replacement device of a
higher version.
• In this case, we recommend to load the very precise motor data available from
»Engineer« V2.17 or to execute the "advanced motor parameter identification"
( C02867/1 = 2).  Automatic motor data identification ( 138)
• As an alternative, the slip calculation from the motor nameplate data can be set again
in C02879/1 (bit 1 = "0") to obtain the previous behaviour.