Lenze 8400 HighLine - Manual (Page 1082)

15 Parameter reference
15.2 Parameter list | C01251
1082
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01251
Bit 9 SpeedNormConstant: Up-Limit 1 ≡ Due to the set machine parameters, an internal
calculation constant is limited to a possible maximum.
Remedy: Reduce reference speed in C00011 .
Bit 10 Max. speed limit 1 ≡ Due to the set machine parameters, the maximum
speed for specifications in [units/s] are limited to the
factor 150 %.
Bit 11 Quick stop is active 1 ≡ Quick stop function is active.
Bit 12 Quick stop standstill is active 1 ≡ Standstill during active quick stop function (no ramp
generation).
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Bit 16 Reserved
Bit 17 Reserved
Bit 18 Reserved
Bit 19 Reserved
Bit 20 Reserved
Bit 21 Reserved
Bit 22 Reserved
Bit 23 Reserved
Bit 24 Reserved
Bit 25 Reserved
Bit 26 Reserved
Bit 27 Reserved
Bit 28 Reserved
Bit 29 Reserved
Bit 30 Reserved
Bit 31 Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C01247 | MCK: Diagnostic word
Data type: UNSIGNED_32
Index: 23328
d
= 5B20
h
Parameter | Name:
C01251 | MCK: Acceleration stop
Data type: INTEGER_32
Index: 23324
d
= 5B1C
h
Acceleration parameter for stop
 Stop
Setting range (min. value | unit | max. value)
-214748.3647 units/s2 214748.3647
Subcodes Lenze setting Info
C01251/1 720.0000 units/s2 MCK: Stop: Decel.
• Deceleration for setpoint speed ramp-down to
standstill.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000