Lenze 8400 HighLine - Manual (Page 275)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
275
5 Motor control (MCTRL)
5.11 Encoder/feedback system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Parameterisation dialog in the »Engineer«
Short overview of the relevant parameters:
Parameter Info Lenze setting
Value Unit
Encoder selection / General settings
C00495 Speed sensor selection
• Source of feedback signal for speed control.
0: No sensor
C00490 Position encoder selection
• Source of feedback signal for position control.
0: no sensor: nSpeedSetValue_a
C00254 Kp position controller 5.00 1/s
C01206/1 MCK: Mounting direction: Motor 0: Not inverted
C01206/2 MCK: Mounting direction: Position encoder 0: Not inverted
C00051 MCTRL: Actual speed value - rpm
C01210/3 MCK: Actual position - units
Highlighted in grey = display parameter