Lenze 8400 HighLine - Manual (Page 1132)

15 Parameter reference
15.2 Parameter list | C02610
1132
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02610
C02611
Parameter | Name:
C02610 | MCK: Accel./decel. times
Data type: UNSIGNED_32
Index: 21965
d
= 55CD
h
Ramp times for speed setpoint synchronisation
Setting range
(min. value | unit | max. value)
0.000 s 999.999
Subcodes Lenze setting Info
C02610/1 2.000 s Holding brake: ramp time synchr.
• Ramp time for the synchronisation process to
setpoint speed after the brake opening time has
elapsed
Revised behaviour from version 11.00.00:
• The setting made here is only effective if bit 6
"SyncRampe L_NSet_1" in C02582 is set to "0".
• In the Lenze setting of C02582 (Bit 6 = "1"), the ramp
time of the effective acceleration of the ramp
function generator ( L_NSet_1 ) is used.
 Holding brake control
C02610/2 2.000 s MCK: Ramp time synchr. setpoint
• Time for synchronisation ramps between setpoint
jumps occurring through the exceedance of
minimum and maximum speed setpoint limit ranges.
C02610/3 2.000 s MCK: SM stopping ramp
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C02611 | MCK: Limitations
Data type: INTEGER_16
Index: 21964
d
= 55CC
h
Speed setpoint limits for the determination of limited validity ranges
Note:
Traversing with setpoints through resulting blocking zones is executed with the ramp set in C02610/2 .
 Speed Min/Max
Setting range (min. value | unit | max. value)
0.00 % 199.99
Subcodes Lenze setting Info
C02611/1 199.99 % MCK: Pos. max. speed
• Upper limit of the speed setpoint limitation in
positive direction of rotation.
C02611/2 0.00 % MCK: Pos. min. speed
• Lower limit of the speed setpoint limitation in
positive direction of rotation.
C02611/3 0.00 % MCK: Neg. min. speed
• Lower limit of the speed setpoint limitation in
negative direction of rotation.
C02611/4 199.99 % MCK: Neg. max. speed
• Upper limit of the speed setpoint limitation in
negative direction of rotation.
C02611/5 0.50 % MCK: Max. speed
• From version 12.00.00
• Maximum value for transferring the current speed to
the speed setpoint when the internal operating mode
" StandBy " is exited.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100