Lenze 8400 HighLine - Manual (Page 1083)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
1083
15 Parameter reference
15.2 Parameter list | C01252
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01252
C01294
C01295
Parameter | Name:
C01252 | MCK: S-ramp times stop
Data type: UNSIGNED_16
Index: 23323
d
= 5B1B
h
S-ramp times for stop
• Setting "0 s" ≡ no rounding
 Stop
Setting range (min. value | unit | max. value)
0.000 s 10.000
Subcodes Lenze setting Info
C01252/1 0.000 s MCK: Stop: S-ramp time
• S-ramp time for setpoint speed ramp-down to
standstill.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C01294 | Mode: Position calculation
Data type: UNSIGNED_8
Index: 23281
d
= 5AF1
h
From version 12.00.00
Selection of the conversion mode
Selection list
0 dnOut_p=ConvWordsToDInt(HW_L
W)
1 16 bits: LW=+/-32767
2 16 bits: HW=+/-; LW=0..65535
3 32Bit: HW_LW=+/-214748.3647
Subcodes Lenze setting Info
C01294/1 0:
dnOut_p=ConvWordsToDInt(HW_L
W)
L_ConvUnitsToIncr_1 : PosCalcMode
C01294/2 0:
dnOut_p=ConvWordsToDInt(HW_L
W)
L_ConvUnitsToIncr_2 : PosCalcMode
C01294/3 0:
dnOut_p=ConvWordsToDInt(HW_L
W)
L_ConvUnitsToIncr_3 : PosCalcMode
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01295 | L_MCKStateInterface_1: Pos. selection
Data type: UNSIGNED_8
Index: 23280
d
= 5AF0
h
From version 04.00.00
Selection of the position to be provided at the dnPosOut_p output of the FB L_MckStateInterface
Selection list (Lenze setting printed in bold)
0 dnPosIn_p
1 Current feed
2 dnSetPos_p
3 dnActPos_p
4 dnDeltaPos_p
5 dnTargetPos_p
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1