Lenze 8400 HighLine - Manual (Page 34)

2 Introduction: Parameterising the controller
2.3 General notes on parameters
34
Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3.1 Changing the parameterisation with the keypad
Keypad display and control elements
The keypad is simply plugged on the diagnostic
interface X6 ("DIAG") at the front of the standard
device.
Plugging and unplugging the keypad is possible
during operation.
LCD display
Headline
In the menu level: Menu name
In the parameter level: Parameter name
Three-part display
In the menu level: List of available menus
In the parameter level: Code/subcode and setting or actual value
Device status
 Controller is switched on  Pulse inhibit active
 Controller is enabled  System fault active
 Controller is inhibited  "Fault" device status is active
 Quick stop active  "Trouble" device status is active
 Current limit exceeded  "TroubleQSP" device status is active
 Speed controller 1 in the limitation  A warning is indicated
WXST VYR
+HDGOLQH
7ULSOHOLQHGLVSOD\
&XUUHQWIXQFWLRQ
ULJKWIXQFWLRQNH\ &XUUHQWIXQFWLRQ
OHIWIXQFWLRQNH\
/&'GLVSOD\
'HYLFHVWDWH
,QPDQXDOFRQWUROPRGH
6WDUWPRWRU ,QPDQXDOFRQWUROPRGH
6WRSPRWRU