Lenze 8400 HighLine - Manual (Page 1071)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
1071
15 Parameter reference
15.2 Parameter list | C01226
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01226
C01227
C01228
Parameter | Name:
C01226 | MCK: Ref. S-ramp time
Data type: UNSIGNED_16
Index: 23349
d
= 5B35
h
S-ramp time for reference search/homing
• Setting "0 s" ≡ no rounding
 Homing
Setting range (min. value | unit | max. value)
0.000 s 10.000
Subcodes Lenze setting Info
C01226/1 0.000 s MCK: Ref. S-ramp time
• S-ramp time for the starting and search speed ramps.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C01227 | MCK: Ref. positions
Data type: INTEGER_32
Index: 23348
d
= 5B34
h
Positions for determining the zero position of the reference measuring system
 Homing
Setting range (min. value | unit | max. value)
-214748.3647 unit 214748.3647
Subcodes Lenze setting Info
C01227/1 0.0000 unit MCK: Ref. offset reference degree
• Relative traverse path by which the drive traverses
correctly signed with search speed after detection of
the sensor reference signal.
C01227/2 0.0000 unit MCK: Ref. home position
• Position with which setpoint and actual position are
loaded after completion of homing.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01228 | MCK: Ref. sequence profile
Data type: UNSIGNED_8
Index: 23347
d
= 5B33
h
Number of the sequence profile the absolute position of which will be approached after homing.
 Homing
Setting range (min. value | unit | max. value) Lenze setting
0 15 0
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1