Lenze 8400 HighLine - Manual (Page 1463)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14
1463
17 Function library
17.1 Function blocks
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
17.1.137.2 Function at input value with sign reversal
Selection: C01150 = "2: Loading with level + reset"
[17-64] Switching performance if the input signal changes signs
• If "2: Loading with level + reset" is selected in C01150 , the bLoad input is status-controlled: In
case of a TRUE signal, the integrator is loaded with the value at dnSet_p and the bStatus output
is set to FALSE.
• A positive signal at nIn_v is incremented (the counter content is increased with every function
call).
• A negative signal at nIn_v is decremented (the counter content is reduced with every function
call).
• dnOut_p outputs the counter content of the bipolar integrator.
• If the positive counter content is higher than the comparison value set in C01151/x , the
comparison value will be subtracted from the counter content, and bStatus will be set to
TRUE for one task cycle.
• If the negative counter content is lower than the comparison value set in C01151/x , the
comparison value will be added to the counter content, and bStatus will be set to TRUE for
one task cycle.
 Sign reversal of the value at nIn_v
 C01151/x : Comparison value (is valid for both the positive and the negative value range)
dnOut_p
t
0
TRUE
FALSE
bStatus
t
0
Œ
Œ